Show simple item record

dc.contributor.authorHlaváč, Libor
dc.contributor.authorHlaváčová, Irena
dc.contributor.authorGeryk, Vladan
dc.date.accessioned2017-03-08T12:12:49Z
dc.date.available2017-03-08T12:12:49Z
dc.date.issued2017
dc.identifier.citationThe International Journal of Advanced Manufacturing Technology. 2017, vol. 88, issue 1-4, p. 443-449.cs
dc.identifier.issn0268-3768
dc.identifier.issn1433-3015
dc.identifier.urihttp://hdl.handle.net/10084/116899
dc.descriptionV článku uvedeno Libor M. Hlaváč a Irena M. Hlaváčová.cs
dc.description.abstractThe taper, inclination of cut side walls, is one of the characteristic phenomena of the abrasive water jet (AWJ) cutting. The taper represents a serious problem in shape cutting, especially in corners and curvatures. However, deviation of the side walls occurs even in the straight line parts of trajectories. Some differences from character typical for metal cutting have been noticed when studying the rock materials. This article is aimed at the experimental research of the cut walls taper on several rock materials with different genesis and composition. The topic of this contribution to the common knowledge is pointing out the most important differences compared to previous research made mainly on metals. The widths of slots made in plan-parallel plates of rock materials were measured both on the top and on the bottom. The difference between these widths has been used for evaluation of the taper—the angle of the cut walls inclination. The results were compared with the regression equation obtained from experimental results on metals and presented in past. The discrepancy between new findings and previously determined equation is discussed and the most probable explanations are submitted.cs
dc.language.isoencs
dc.publisherSpringercs
dc.relation.ispartofseriesThe International Journal of Advanced Manufacturing Technologycs
dc.relation.urihttp://dx.doi.org/10.1007/s00170-016-8782-2cs
dc.rights© Springer-Verlag London 2016cs
dc.subjectrock materialscs
dc.subjectcuttingcs
dc.subjectabrasive water jetcs
dc.subjecttapercs
dc.subjectinclinationcs
dc.titleTaper of kerfs made in rocks by abrasive water jet (AWJ)cs
dc.typearticlecs
dc.identifier.doi10.1007/s00170-016-8782-2
dc.type.statusPeer-reviewedcs
dc.description.sourceWeb of Sciencecs
dc.description.volume88cs
dc.description.issue1-4cs
dc.description.lastpage449cs
dc.description.firstpage443cs
dc.identifier.wos000392308400038


Files in this item

FilesSizeFormatView

There are no files associated with this item.

This item appears in the following Collection(s)

Show simple item record