Show simple item record

dc.contributor.authorMalotová, Šárka
dc.contributor.authorČep, Robert
dc.contributor.authorZlámal, Tomáš
dc.contributor.authorMohyla, Petr
dc.contributor.authorCzán, Andrej
dc.contributor.authorAntić, Aco
dc.contributor.authorBudak, Igor
dc.contributor.authorMircea, Lobonţiu
dc.date.accessioned2018-09-13T12:25:41Z
dc.date.available2018-09-13T12:25:41Z
dc.date.issued2018
dc.identifier.citationTehnicki vjesnik - Technical Gazette. 2018, vol. 25, issue 4, p. 1009-1013.cs
dc.identifier.issn1330-3651
dc.identifier.issn1848-6339
dc.identifier.urihttp://hdl.handle.net/10084/131791
dc.description.abstractResidual stress occurs in many machined components and parts. Over time, several methods have been developed for the investigation of residual stress in the material - destructive and non-destructive. This article deals with the evaluation and comparison of residual stress in the material when machining steel C45 and 11CrMo9-10, when the tool enters into the cut and stands out in conditions of an interrupted cut. A non-destructive method, based on X-Ray diffraction, was applied to evaluate the residual stress. The points were measured on the last machined slat by using interrupted cut simulator. An irregular interrupted cut was achieved by gradually machining 4, 3, 2 and 1 slat. The experiments were realized in co-operation with the Faculty of Mechanical Engineering, VSB - Technical University of Ostrava, Czech Republic and the Faculty of Mechanical Engineering, the University of Zilina, Slovakia.cs
dc.format.extent1132799 bytes
dc.format.mimetypeapplication/pdf
dc.language.isoencs
dc.publisherStrojarski fakultet u Slavonskom Brodu, Elektrotehnički fakultet u Osijeku, Građevinski fakultet u Osijekucs
dc.relation.ispartofseriesTehnički vjesnik – Technical Gazettecs
dc.relation.urihttp://doi.org/10.17559/TV-20160615125650cs
dc.rightsTEHNIČKI VJESNIK - TECHNICAL GAZETTE is an Open Access journal. All content is made freely available. Users are allowed to copy and redistribute, and alter, transform, or build upon the material as long as they attribute the source in an appropriate manner.cs
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/cs
dc.subjectinterrupted cutcs
dc.subjectmachiningcs
dc.subjectresidual stresscs
dc.subjectX-Ray diffractioncs
dc.titleEvaluation of residual stresses after irregular interrupted machiningcs
dc.typearticlecs
dc.identifier.doi10.17559/TV-20160615125650
dc.rights.accessopenAccesscs
dc.type.versionpublishedVersioncs
dc.type.statusPeer-reviewedcs
dc.description.sourceWeb of Sciencecs
dc.description.volume25cs
dc.description.issue4cs
dc.description.lastpage1013cs
dc.description.firstpage1009cs
dc.identifier.wos000442273000009


Files in this item

This item appears in the following Collection(s)

Show simple item record

TEHNIČKI VJESNIK - TECHNICAL GAZETTE is an Open Access journal. All content is made freely available. Users are allowed to copy and redistribute, and alter, transform, or build upon the material as long as they attribute the source in an appropriate manner.
Except where otherwise noted, this item's license is described as TEHNIČKI VJESNIK - TECHNICAL GAZETTE is an Open Access journal. All content is made freely available. Users are allowed to copy and redistribute, and alter, transform, or build upon the material as long as they attribute the source in an appropriate manner.