Show simple item record

dc.contributor.authorHloch, Sergej
dc.contributor.authorHlaváček, Petr
dc.contributor.authorVasilko, Karol
dc.contributor.authorCárach, Ján
dc.contributor.authorSamardžić, Ivan
dc.contributor.authorKozak, Dražan
dc.contributor.authorHlavatý, Ivo
dc.contributor.authorŠčučka, Jiří
dc.contributor.authorKlich, Jiří
dc.contributor.authorKlichová, Dagmar
dc.date.accessioned2014-10-03T08:34:25Z
dc.date.available2014-10-03T08:34:25Z
dc.date.issued2014
dc.identifier.citationMetalurgija. 2014, vol. 53, no. 4, p. 537-540.cs
dc.identifier.issn0543-5846
dc.identifier.issn1334-2576
dc.identifier.urihttp://hdl.handle.net/10084/105793
dc.description.abstractThe paper deals with abrasive waterjet titanium tangential turning. Titanium grade 3 with a diameter of 55 mm was used as an experimental material. Technological conditions of turning tests were the same by gradually changing value of traverse speed (vf = 1,5; 3; 4,5; 6; 7,5 mm·min-1). Experiment tests were performed by using continuous abrasive waterjet of pressure p = 400MPa, by rotation n = 60 rpm of workpiece. The abrasive particles (Barton Garnet) were fed to the waterjet in the amount of 0,4 kg·min-1. It was determined that acceleration of traverse speed did not increase the surface profile parameters.cs
dc.format.extent1049029 bytes
dc.format.mimetypeapplication/pdf
dc.language.isoencs
dc.publisherHrvatsko Metalurško Društvocs
dc.relation.ispartofseriesMetalurgijacs
dc.relation.urihttp://hrcak.srce.hr/file/180661cs
dc.titleAbrasive waterjet (AWJ) titanium tangential turning evaluationcs
dc.typearticlecs
dc.rights.accessopenAccess
dc.type.versionpublishedVersioncs
dc.type.statusPeer-reviewedcs
dc.description.sourceWeb of Sciencecs
dc.description.volume53cs
dc.description.issue4cs
dc.description.lastpage540cs
dc.description.firstpage537cs
dc.identifier.wos000335807600027


Files in this item

This item appears in the following Collection(s)

Show simple item record