Zobrazit minimální záznam

Influence of material structure on forces measured during abrasive waterjet (AWJ) machining

dc.contributor.authorHlaváč, Libor M.
dc.contributor.authorŠtefek, Adam
dc.contributor.authorTyč, Martin
dc.contributor.authorKrajcarz, Daniel
dc.date.accessioned2020-10-26T10:39:31Z
dc.date.available2020-10-26T10:39:31Z
dc.date.issued2020
dc.identifier.citationMaterials. 2020, vol. 13, issue 17, art. no. 3878.cs
dc.identifier.issn1996-1944
dc.identifier.urihttp://hdl.handle.net/10084/142365
dc.description.abstractMaterial structure is one of the important factors influencing abrasive waterjet (AWJ) machining efficiency and quality. The force measurements were performed on samples prepared from two very similar steels with different thicknesses and heat treatment. The samples were austenitized at 850 degrees C, quenched in polymer and tempered at various temperatures between 20 degrees C and 640 degrees C. The resulting states of material substantially differed in strength and hardness. Therefore, samples prepared from these material states are ideal for testing of material response to AWJ. The force measurements were chosen to test the possible influence of material structure on the material response to the AWJ impact. The results show that differences in material structure and respective material properties influence the limit traverse speed. The cutting to deformation force ratio seems to be a function of relative traverse speed independently on material structure.cs
dc.language.isoencs
dc.publisherMDPIcs
dc.relation.ispartofseriesMaterialscs
dc.relation.urihttp://doi.org/10.3390/ma13173878cs
dc.rights© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.cs
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/cs
dc.subjectabrasive waterjetcs
dc.subjectmachiningcs
dc.subjecttraverse speedcs
dc.subjectmaterial structurecs
dc.subjectmaterial propertiescs
dc.subjectcutting forcecs
dc.subjectdeformation forcecs
dc.titleInfluence of material structure on forces measured during abrasive waterjet (AWJ) machiningcs
dc.typearticlecs
dc.identifier.doi10.3390/ma13173878
dc.rights.accessopenAccesscs
dc.type.versionpublishedVersioncs
dc.type.statusPeer-reviewedcs
dc.description.sourceWeb of Sciencecs
dc.description.volume13cs
dc.description.issue17cs
dc.description.firstpageart. no. 3878cs
dc.identifier.wos000570332500001


Soubory tohoto záznamu

Název:
1996-1944-2020v13i17an3878.pdf
Velikost:
3.664Mb
Formát:
PDF
Zobrazit/otevřít

Tento záznam se objevuje v následujících kolekcích

Zobrazit minimální záznam

© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.
Kromě případů, kde je uvedeno jinak, licence tohoto záznamu je © 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.