Zobrazit minimální záznam

Influence of cutting parameters on heat-affected zone after laser cutting

dc.contributor.authorPetrů, Jana
dc.contributor.authorZlámal, Tomáš
dc.contributor.authorČep, Robert
dc.contributor.authorMonková, Katarína
dc.contributor.authorMonka, Peter
dc.date.accessioned2013-05-22T08:20:01Z
dc.date.available2013-05-22T08:20:01Z
dc.date.issued2013
dc.identifier.citationTehnički vjesnik – Technical Gazette. 2013, vol. 20, no. 2, p. 225-230.cs
dc.identifier.issn1330-3651
dc.identifier.urihttp://hdl.handle.net/10084/96356
dc.description.abstractThe article deals with a method of thermal cutting of materials, specifically with laser technology. The theoretical part describes its principles, capabilities and use of laser in the process of machining, mainly the procedure of cutting material using a laser beam. The experimental part is focused on cutting the cobalt alloy by a continuous CO2 laser and the influence of technological parameters during cutting on the final quality of the cutting area. Suitable technological parameters were determined on the basis of metallographic analysis, and the lowest heat influence on the material was achieved.cs
dc.format.extent2180533 bytescs
dc.format.mimetypeapplication/pdfcs
dc.language.isoencs
dc.publisherSveučilište J.J. Strossmayera u Osijeku. Strojarski fakultetcs
dc.relation.ispartofseriesTehnički vjesnik – Technical Gazettecs
dc.relation.urihttp://hrcak.srce.hr/file/147567cs
dc.subjectheat-affected zone (HAZ)cs
dc.subjectlaser cuttingcs
dc.subjectlaser parametercs
dc.subjectmachiningcs
dc.subjectlaserski parametarcs
dc.subjectlasersko rezanjecs
dc.subjectobrada odvajanjem česticacs
dc.subjectzona utjecaja topline (ZUT)cs
dc.titleInfluence of cutting parameters on heat-affected zone after laser cuttingcs
dc.title.alternativeUtjecaj parametara rezanja na zonu utjecaja topline nakon laserskog rezanjacs
dc.typearticlecs
dc.identifier.locationNení ve fondu ÚKcs
dc.description.abstract-enČlanak se bavi metodom toplinskog rezanja materijala, posebice laserskom tehnologijom. U teorijskom dijelu opisan je njezin princip, mogućnosti i uporaba lasera u procesu obrade odvajanjem čestica; uglavnom postupak rezanja materijala uporabom laserskog snopa. Eksperimentalni dio usredotočen je na rezanje kobaltne legure pomoću neprekidnog lasera CO2 i utjecaj tehnoloških parametara tijekom rezanja na završnu kvalitetu područja rezanja. Na temelju metalografske analize utvrđeni su pogodni tehnološki parametri i postignut najniži utjecaj topline na materijal.cs
dc.rights.accessopenAccess
dc.type.versionpublishedVersioncs
dc.type.statusPeer-reviewedcs
dc.description.sourceWeb of Sciencecs
dc.description.volume20cs
dc.description.issue2cs
dc.description.lastpage230cs
dc.description.firstpage225cs
dc.identifier.wos000317728700004


Soubory tohoto záznamu

Název:
tv_20_2013_2_225_230-petru.pdf
Velikost:
2.079Mb
Formát:
PDF
Popis:
publishedVersion
Zobrazit/otevřít

Tento záznam se objevuje v následujících kolekcích

Zobrazit minimální záznam