Influence of scanning strategy parameters on residual stress in the SLM process according to the Bridge Curvature Method for AISI 316L stainless steel
| dc.contributor.author | Hajnyš, Jiří | |
| dc.contributor.author | Pagáč, Marek | |
| dc.contributor.author | Měsíček, Jakub | |
| dc.contributor.author | Petrů, Jana | |
| dc.contributor.author | Król, Mariusz | |
| dc.date.accessioned | 2020-06-18T12:23:32Z | |
| dc.date.available | 2020-06-18T12:23:32Z | |
| dc.date.issued | 2020 | |
| dc.description.abstract | The present paper deals with the investigation and comparison of the influence of scanning strategy on residual stress in the selective laser melting (SLM) process. For the purpose of the experiment, bridge geometry samples were printed by a 3D metal printer, which exhibited tension after cutting from the substrate, slightly bending the samples toward the laser melting direction. Samples were produced with the variation of process parameters and with a change in scanning strategy which plays a major role in stress generation. It was evaluated using the Bridge Curvature Method (BCM) and optical microscopy. At the end, a recommendation was made. | cs |
| dc.description.firstpage | art. no. 1659 | cs |
| dc.description.issue | 7 | cs |
| dc.description.source | Web of Science | cs |
| dc.description.volume | 13 | cs |
| dc.identifier.citation | Materials. 2020, vol. 13, issue 7, art. no. 1659. | cs |
| dc.identifier.doi | 10.3390/ma13071659 | |
| dc.identifier.issn | 1996-1944 | |
| dc.identifier.uri | http://hdl.handle.net/10084/139546 | |
| dc.identifier.wos | 000529875600177 | |
| dc.language.iso | en | cs |
| dc.publisher | MDPI | cs |
| dc.relation.ispartofseries | Materials | cs |
| dc.relation.uri | http://doi.org/10.3390/ma13071659 | cs |
| dc.rights | © 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license. | cs |
| dc.rights.access | openAccess | cs |
| dc.rights.uri | http://creativecommons.org/licenses/by/4.0/ | cs |
| dc.subject | scanning strategy | cs |
| dc.subject | residual stress | cs |
| dc.subject | SLM | cs |
| dc.subject | AISI316L | cs |
| dc.subject | BCM | cs |
| dc.title | Influence of scanning strategy parameters on residual stress in the SLM process according to the Bridge Curvature Method for AISI 316L stainless steel | cs |
| dc.type | article | cs |
| dc.type.status | Peer-reviewed | cs |
| dc.type.version | publishedVersion | cs |