Návrh ručního zařízení pro děrování plechových profilů

Abstract

The merits of the thesis is to draft a device for perforation of cross-section piece. The cross-section piece with a hole inside is included in requirements for the device. The thesis is divided into seven chapters. Brief introduction about the purpose for which the device is developed is desribed at the first chapter. In the following chapter there are mentioned devices with producers, which can use my solution. In the technical draft I am looking for, according to my experience, the best posisible solution to fully meet the defined requirements. The technical draft is then constructionally solved in details on the next chapters. Calculation of chosen parts is dimensed or verified following the possible load. The evaluation of complete device is executed at the end of the thesis.