Sledování silových poměrů při vysokoposuvovém frézování

Abstract

Presented thesis focuses on study of forces during the process of high feed cutting. The introduction includes analysis of current status of the analyzed problem and goals of the thesis are set. The introduction also contains of a theoretical study including force distribution during face milling, methods of calculation of cutting forces, used machines, tools and materials. The experimental part of the thesis contains of measurements done during the experiment, its scheme and cutting conditions. It is followed by evaluation of the experiment, evaluation of results of cutting forces as well as creation of structural equations and binary graphs, that reflect the properties of used materials during the cutting process. The conclusion of the thesis contains of detailed description of experiment evaluation. It is followed by confirmation of use of applicable tools for cutting of selected materials with specific hardnesses. The conclusion also includes comparison of using five-tooth and six-tooth cutter and determination coefficient.