Návrh kalibrace kontrolních kroužků

Abstract

IRIŠEK, D. Calibration Proposal of Control Rings: Master Thesis. Ostrava: VŠB-Technical University of Ostrava, Faculty of Mechanical Engineering, Department of Working and Assembly, 2011, 58 s. Thesis head: doc. Ing. Vladimír Vrba CSc. This thesis is focused on proposal of control rings calibration for length gauge and determination of measuring uncertainty. There is description of the way of length gauge measurement, measurement methodology, devation of measurement and general explanation of the evaluation uncertainty measuring procedure in the theoretical part of thesis. Then there is explained function of the control rings and where the control rings are used. There is description of the calibration preparation of the control rings, way of measurement and description of problems which should be avoided during calibration in the practical part of thesis.Then follows description of the length gauge calibration. There is final evaluation of the uncertainty measuring with technical and economical evaluation in the last chapter.